User manual

10 11
click!
Forward-facing belt installation
It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
!
9-
(18)
Adjust the belt guiding hook outwards
with the ratchet (19). Continue
tightening until the seat is pressed
well into the back rest of the car seat.
Push the head rest in the correct
position (refer to ‘Positioning of the
child’ on page 12). The seat is now
ready to use.
10-
(19)
Put the shoulder belt through the
belt clamps. Make sure the belt is
not twisted (18).
7-
8-
When mounting in the back seat of the vehicle,
push the front seat of the vehicle forward as much
as possible.
When mounting in the front seat of the vehicle, adjust the back
rest in an upright position.
Remove the floor support and the
front brace from the seat.
Put the child seat on the seat of the
vehicle. Unlock the belt clamps (15).
Pull the hip belt around the bottom
base of the seat and click the car
belt in the buckle (17).
Position the hip belt over the belt
guiding hook (17).
1-
2-
3-
4-
5-
6-
(15)
(17)
(16)
Release the release handle at the
back of the head rest and push the
head rest down while keeping the
head rest upright (16).
Push the seat firmly into the car seat.
Tight installation is most important
for forward facing seats.
Tension the belts as follows:
Pull the shoulder belt upwards (A).
Have a firm grip on the shoulder
belt in the seat area (B). Close the
clamp on the inner side (C).
Pull upper belt part on the door
side and close clamp D (18).
A
C
D
B
If the seat is installed in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
Loosen the tension in the car belt by moving the belt guiding
hook inwards with the ratchet, not further than the stop sign.
Unlock the belt clamps and unlock the car belt.
Remove the car belt and remove the seat from the vehicle.
Removing the seat
2-
1-
3-
4-