User manual

8 9
(11)
16- Lock the floor support with
the locking bolt (11).
15- Move the front brace outwards
with the ratchet. Continue
tightening until the brace is
pressed well into the back rest
of the vehicle seat (10).
(10)
(12)
(13)
(14)
Positioned in the back seat of the
vehicle, you should, if possible,
push the front seat of the vehicle
backwards, so that it is in contact
with the child seat. If it is not
possible to obtain contact with the
child seat, push the back rest of the
front seat of the vehicle forward so
that the distance between child seat
and back rest of the front seat of
the vehicle is minimum 25 cm.
Positioned in the front seat of the
vehicle, you should position the
seat against the dashboard.
17-
• Make sure the floor support is fully pushed down, in
contact with the floor of the vehicle, and locked.
• Make sure all ISOfix indicators are green before you drive.
!
If the seat is installed in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible
Remove the locking bolt from the floor support, adjust the
floor support in the highest position and lock again with the
locking bolt.
Move the front brace inwards with the ratchet, not further than
the stop sign.
Release the ISOfix connectors
by pressing the release
mechanism on the ISOfix
connectors (13).
Push the switch on each side
and push the ISOfix connectors
into the base (14).
Pull the seat back towards the front. Turn the seat so you can
easily remove the seat.
Remove the insertion clips from the vehicle. Place them under
the base of the child seat.
Removing the seat
1-
3-
2-
4-
5-
6-
7-