Mi Wireless Outdoor Security Camera 1080p User Manual
Read this manual carefully before use, and retain it for future reference. Precautions . The operating temperature range for this camera is -20°C to 50°C. Do not use this camera in environments with temperatures higher or lower than the specified operating range. . This camera is a precision electronic product that has an IP65 waterproof rating. Do not expose this camera to extremely humid environments or locations that are prone to water getting into the camera, to avoid affecting normal use. .
Product Overview Package Contents Outdoor Camera (Including Battery) Mounting Template Sticker Wall Plug × 3 User Manual Warranty Notice Attention Sticker Screw × 3 Charging Cable (1 m) Note: Illustrations of product, accessories, and user interface in the user manual are for reference purposes only. Actual product and functions may vary due to product enhancements.
Outdoor Camera Indicator Light Sensor Lens Infrared Sensor Microphone Power Button Type-C Charging Port Speaker 3
Outdoor Camera Installation 1. Paste the mounting template sticker on the wall. 2. Drill two holes in the wall according to the positions of the holes on the mounting template sticker, the holes should have a diameter of about 5 mm and a depth of about 26 mm. 3. Install the wall plugs into the drilled holes. 4. As shown in the figure, remove the anti-theft screw from the base and push the camera up to remove it from the base mounting plate.
5. Install the base mounting plate on the wall with the screw. Note: The anti-theft screw hole should face downwards. Anti-theft Screw Hole 6. Keep the button of the outdoor camera facing downwards and rotate the base of the outdoor camera 180° so that the anti-theft screw hole faces downwards. 7. Install the outdoor camera on the base mounting plate and tighten the anti-theft screw.
How to Use Charging: Please fully charge the outdoor camera before using it. Turning on/off: Press the power button to turn on/off the outdoor camera. Resetting: When turned on, press and hold the power button for 5 seconds, and the indicator will blink orange once the outdoor camera has been reset successfully.
. Open the home page of the Mi Home app, tap the + icon in the top right corner, scan the QR code of the outdoor camera body, and complete the pairing by following the instructions in the app. The indicator will turn off after pairing successfully. Note: . This product only supports connecting to a 2.4 GHz Wi-Fi network, and does not support 5 GHz Wi-Fi networks. The indoor receiver can also be connected with an Ethernet cable. .
Battery Safety This device is equipped with a built-in battery that cannot be removed or replaced. Do not disassemble or modify the battery by yourself. WEEE Information All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste.
