Installation and User Manual
ManualsBrandsBertazzoni ManualsBottom Mount Refrigerators31 Inch Counter Depth Bottom Freezer Refrigerator with 17.1 Total Capacity, Surround Cooling System, Total No-Frost System, Full-Width Humidity-Controlled Crisper, Electronic LED Touch Interface, Super Freeze Cycle, LED Lighting and Flat Front Stainless S
17
Replacement Instructions
1.Shut off water supply.
2.Remove clips from each end of the old
water filter.
3.Press down on collar at one end of the filter
and pull the tube out of the filter.
4.Repeat Step 3 on the other end of the filter.
5.Note the Flow direction on the filter.
WATER
SUPPLY INLET→ ←PERMEATE
SIDE
6.Insert water supply tube into the inlet side of
the filter until the tube stops.
Note: You must also ensure that the cut is
square and not at any sort of angle as this
could cause a leak.
7.Repeat Step 6 on the outlet side of the filter.
8.After inserting tube, re-install the clip
between the collar and the filter, making sure
it is secure. The clip will secure the tube to the
filter.
9. Turn on the water and check for leaks. If
leaks occur, repeat Step 1 through 8. If leaks
persist, discontinue use and call your
supporting dealer.
10. Flush filter for 5 minutes before use.
IMPORTANT:
The warranty does not cover any parts, labor, or
damage to property caused by improper
installation, use, maintenance, repair or service.