Install Guide

19


GASCONNECTION
All gas connections must comply with national
and local codes. The gas supply line (service)
must be the same size or greater than the inlet
lineof theappliance. This range usesa 1/2"NPT
inlet (see drawing below for details of gas
connection). On all pipe joints use appropriate
sealant
resistanttogas.
This range can be used with Natural or
LP/Propane gas. The range is  shipped from the
factoryforusewithnaturalgas.
For LP/propane household installation, the
appliance mustbe converted bythe dealer, bya
factory‐trained professional or by a qualified
licensedplumberorgas
servicecompany.
Gasconversionisimportantforsafeandeffective
useoftheappliance.Itistheresponsibility ofthe
dealerandtheowneroftherangetope rformthe
appropriate gas conversion following  the
directionsofthemanufacturer.
THEGASCONVERSIONPROCEDUREIS
DESCRIBEDINTHISMANUALANDINTHE

PACKAGECONTAININGTHECONVERSION
NOZZLESSHIPPEDWITHEVERYRANGE.
Pleaseprovidetheservicepersonwiththis
manualbeforeworkisstartedontherange.

WARNING!
DONOTUSEANOPENFLAMEWHENCHECKING
FORLEAKS!
Leak testing of the appliance shall be conducted
according to the manufacturer's instructions.
Before placing
 the oven into operation,  always
check for leaks with soapy water solution or
otheracceptablemethod.

MANUALSHUT‐OFFVALVE
THISVALVEISNOTSHIPPEDWITHTHE
APPLIANCEANDMUSTBESUPPLIEDBYTHE
INSTALLER.
The manual  shut‐off valve must be installed in
the gasservice linebetween the
 gashook‐up on
the wall and the appliance inlet, in a position
whereitcanbereachedquicklyintheeventofan
emergency.
In Massachusetts: A 'T' handle type manual gas
valve must be installed in the gas supply line to
thisappliance.

FLEXIBLECONNECTIONS
In case of
 installation with flexible couplings
and/or quick‐disconnect fittings, the installer
must use a heavy‐duty, AGA design‐certified
commercial flexible connector of at least 1/2"
(1.3 cm) ID NPT (with suitable strain reliefs) in
compliance with ANSI Z21.41 and Z21.69
standards.
In Massachusetts: The unit must be installed
witha
36"(3‐foot)longflexiblegasconnector. 
InCanada:useCAN1‐6.10‐88metalconnectors
forgasappliancesandCAN1‐6.9M79quick
disconnectdeviceforusewithgasfuel.

PRESSURETEST‐POINTSTOPPERVALVE
To avoid gas leaks, the pressure test‐point
stoppervalveandgaske tsupplied
withtherange
mustbeinstalledonthegasfittingatthebackof
therangeaccordingtothediagrambelow.



 
