INSTALLATION, MAINTENANCE AND USE INSTRUCTIONS FOR Model PM363I0X DIMENSIONS: (890 mm)(W) (520 mm)(D)
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR’S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. OBSERVE ALL GOVERNING CODES AND ORDINANCES. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors and liquid in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS - Do not try to light any appliance.
INDEX: Installation Instructions……………………………………..………………………………………… Inserting the hotplate……………………………………………..………………………………….. Requirements……………………………………..……………………………….…………………. Attaching the hotplate……………………………………..…………………………………………. Gas connection……………………………………..…………………………………………………. Electrical connection……………………………………..……………………….…………………. Room ventilation…………………………………….……………………………………………….. Location and venting…………………………………….………………………………………….. Replacement of nozzles……………………………………..
INFORMATION FOR THE INSTALLER The installation, all regulations, changes and maintenance referred to in this part must only be carried out by qualified staff. A wrong installation can cause damage to persons, animals or things which the manufacturer cannot be held responsible for. The safety and automatic regulation devices on the appliances can only ever be changed by the manufacturer or by the supplier which has been authorised to do so.
(*) Note: -B1 is the min. clearance between the front edge of the appliance and the front edge of the cabinet. -B2 and B4 are the min. clearance between the left/right side edge of the appliance and the side wall (if present). -B3 is the min. clearance between the back edge of the appliance and the back wall. -L2 plus L8 is the minimum distance from the top of the bench to the top of the board fitted to prevent access to the underside of the appliance.
CONNECTING THE APPLIANCE TO THE GAS SUPPLY Before connecting the appliance to the gas supply you first need to remove the plastic protective plug for the gas supply which is inserted under pressure in the gas inlet connection. To remove the plug simply unscrew it. Then make sure that the details shown on the label on the lower part of the case are compatible with those of the gas supply.
Before making the connection check that: the switch, wiring and electrical system can support the appliance load (see data plate); the power supply system has an efficient earthing connection which complies with the provisions of current regulations; the power outlet or omnipoar circuit-breaker is easily accessible once the cooker has been installed.
DESCRIPTION DESCRIPTIVE CAPTION FOR HOB (fig.9) 1. Dual burner 2 Rapid burner 3. Rear Induction element 4. Front induction element 5. Semi-rapid burner 6. Dual out burner control knob 7. Dual in burner control knob 8. Rapid burner control knob 9. Medium burner control knob 10. Front Induction element control knob 11. Rear Induction element control knob BEFORE LEAVING When the installation is complete, always check for gas leaks using a soapy solution. Never use a flame to make this check.
Wear Proper Apparel - Loose-fitting or hanging garments should never be worn while using the appliance. User Servicing - Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Storage in or on Appliance - Flammable materials should not be stored near surface units. Do Not Use Water on Grease Fires - Smother fire or flame or use dry chemical or foam-type extinguisher.
Do not store dangerous or flammable material in the cabinet areas above appliance; store them in a safe place in order to avoid potential hazards. For safe use of appliance, do not use it for space heating. Do not use aerosol sprays in the vicinity of this appliance while it is in operation For description of hotplates refer to installation instructions. USING BURNERS A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob. (fig.
WARNING: If the power is cut off, the burners can be lit with matches. The burners equipped with a safety thermocouple can only be lit when the knob is in the MAXIMUM position (large flame etching). Note: The use of a gas cooking appliance produces heat and humidity in the room where it is installed. Therefore, proper ventilation in the room is needed and natural ventilation openings must remain unobstructed and activating the mechanical exhaust fan/range hood.
The Principle of Induction When an induction element, also called: ‘a heating zone’ or simply: ‘a coil’ - is switched on, the appropriate piece of cookware used, and a desired level of heating power selected, the electronic circuit unit (‘induction generator’ or ‘inverter’) powers up the induction element which creates a magnetic field.
Heating accelerator Each cooking zone is equipped with a heating accelerator. This system allows the zone to be operated at peak power for a time proportional to the heating power selected. To start the heating accelerator, turn the knob to the left, select setting "A" and then release. You now have 3 seconds to select the heating setting between 1 and 9. While the heating accelerator is in operation, the heating level can be increased at any time. The "full power" time will be modified accordingly.
Important!Keep a close eye on children because they are unlikely to see the residual heat warming lights. The cooking zones are still very hot for some time after use, even if they are switched off. Make sure that children never touch them. WARNING: Under no circumstance use aluminum foil or plastic containers to hold the food while cooking on a glass-ceramic hob.
Your cooktop must never be used as a storage space or a surface for piling up of any material. Do not connect any appliances to the plugs above or near to the induction cooktop; connection cable insulation can melt if in contact with heat, and this may result in an injury and property damage. Cooking recommendations FOOD KNOB POSITION Melting Chocolate, chocolate coating, butter 1-2 Heating Frozen vegetables eg.
Cleaning the glass ceramic: Warning: Do not use any kind of cleaner on the glass while the surface is hot, use only the razor blade scraper. The resulting fumes can be hazardous to your health. Heating the cleaner can chemically attack and damage the surface. Clean the surface when it is completely cool with the following exception: remove dry sugar, sugar syrup, tomato products and milk immediately with the razor blade scraper. Wipe off spatters with a clean, damp sponge or a paper towel. Rinse and dry.
Troubleshooting You have doubts about whether your cooktop is working correctly this does not necessarily mean there is a breakdown.
WARNING: Disconnect power before servicing unit. WARNING: The power cord supplied with the appliance is connected to the appliance with a type Y connection (in compliance with standards EN 60335-1, EN 60335-2-6 and subsequent amendments) for which it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Fig. 1 Fig. 2 Fig.3 Fig.3A Fig.3B Fig.
Fig. 4A Fig. 4B Fig.5 Fig.
Fig.7 Fig.8 Fig.9 Fig.
Fig.11 Fig.12 Fig.13 Fig.14 Fig.15 Fig.16 Fig.17 Fig.
Fig.19 Fig.20 Fig.
Cod.
