Installation Manual

6
/ Before installation
• This appliance shall only be installed by an
authorized professional.
If the installation requires alterations to the dome-
stic electrical system, call a qualifi ed
electrician.
The electrician should also check that the socket
cable section is suitable for the electricity drawn
by the oven.
• This appliance shall be installed in accordance
with the manufacturer’s installation
instructions.
• This appliance must be installed in accordance
with the norms & standards of the country
where it will be installed.
• The installation of this appliance must conform
to local codes and ordinances. In the absence
of local codes, Installations must conforms to
American National Standards.
• Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
proper airfl ow for optimal oven performance.
•
All opening and holes in the wall and fl oor, back
and under the appliance shall be sealed before
installation of the appliance.
The installation, adjustments, transformations and
maintenance listed in this section must only be
performed by qualifi ed technicians (in accordance
with applicable legislation). Incorrect installation
can cause property damage and injury to people
or pets; the manufacturer shall not be held liable
in this event. The appliance’s automatic regulation
or safety devices may only be modifi ed by the
manufacturer or a duly authorised technician
during the appliance’s lifetime.
Ensure all necessary PPE is used when
carrying out the installation
ROOM VENTILATION
An exhaust fan may be used with the appliance;
in each case it shall be installed in conformity
with the appropriate national and local standards.
Exhaust hood operation may aff ect other vented
appliances; in each case it shall be installed in
conformity with the appropriate national and local
standards.
Do not use aerosol sprays in the vicinity of
this appliance while it is in operation.
CABINET REQUIREMENT
To prevent possible damage to cabinets and ca-
binet fi nishes, use only materials and fi nishes that
will not discolor or delaminate and will withstand
temperatures up to 195°F (90°C). Heat resistant
adhesive must be used if the product is to be in-
stalled in laminated cabinetry. Check with your
builder or cabinet supplier to make sure that the
materials meet these requirements.
Installation of the appliance must be performed
in accordance with the provisions of applicable
legislation.
• BE SURE that support for this appliance is
perpendicular to the front facing of the wall or
cabinet before you perform the installation.
The cabinet base must be fl at and capable of
supporting the weight of the oven when in use.
Minimum Suggested Load on Cabinet Base Board
weight lb weight kg
480
220
BEFORE INSTALLATION