Operation Manual

22
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT CAUSE SOLUTION
My accessories and shelf
supports are damaged.
You have not removed the
accessories and supports
during the pyrolytic cleaning
cycle.
You must replace them and
remove them in later cleaning
cycles.
The enamel colour has
changed or stains have
appeared.
The chemical composition
of some foodstuffs may cause
changes in the enamel.
This is normal and does not
damage the properties of the
enamel.
A flashing symbol
appears on the temperature
display (2) and an alarm
sounds.
The oven is programmed
to carry out a pyrolytic
cleaning cycle but the door is
open.
Close the door to enable the
function to be carried out.
I have programmed the
pyrolytic function, the oven is
working properly but indicator
light (3) is not lit up.
Indicator light (3) does not
work properly.
Call the Technical Assistance
Service.
The pyrolytic programme has
finished but the oven door is
locked.
The oven has not cooled
down to the safe
temperature.
Wait until the oven cools
down and indicator light (3)
turns off.
A flashing symbol E:1
appears on the temperature
display (2) and an alarm
sounds. The oven has
stopped heating up.
The oven door has not been
locked. The door is not closed
properly and cannot be
locked.
Touch any sensor to stop the
alarm. Check the door and
make sure that it is closed
properly.
1 2 3 4 5 6 7 8 9
1112 10