Instruction manual

25

The oven will begin pre-heating and signal the end of the pre-heating cycle with a
tone. Insert the food in the oven only after the pre-heating is complete.
The display will show the time remaining until the end of the cooking sequence.
The oven will turn off at the end of the cooking cycle. The display will show END OF
COOKING – BUON APPETITO! End of cooking will be confirmed with a tone.
Important: COOKING WILL CONTINUE WITH RESIDUAL HEAT. REMOVE THE DISH FROM
THE OVEN IMMEDIATELY TO AVOID OVERCOOKING.
FOOD PROBE If the cooking sequence requires the use of the food probe, the display will ask you
to input the desired food temperature (lower = rare, higher = well done). Once the
pre-heating cycle is completed, the display will remind you to insert the food probe.
Connect the food probe jack to the appropriate port in the oven cavity at the end of
preheating. The cooking sequence will start only after confirmation that the food
probe has been inserted.
When using the food probe, the display will show the food probe temperature (actual
and target) instead of the remaining time until the end of cooking.
The oven will turn off when the food temperature measured by the probe reaches
the desired level. The display will show END OF COOKING – BUON APPETITO!
End of cooking will be confirmed with a tone.
Important: COOKING WILL CONTINUE WITH RESIDUAL HEAT. REMOVE THE DISH FROM
THE OVEN IMMEDIATELY TO AVOID OVERCOOKING.
STOP/MODIFY To STOP cooking tap and confirm.
It is not possible to change cooking mode, temperature or duration while cooking
with the ASSISTANT function. If additional cooking is needed, operate the oven in
manual mode until the desired result is obtained.
Important Pre-programmed sequences have been calibrated for cooking food starting from
room temperature. If using frozen food for a dish, defrost it before starting a
sequence.