Instruction Handbook
your rearm and severe injury to both the shooter
and other individuals. Use ammunition approved
by the
U.S. Sporting Arms and Ammunition Manu-
facturers. Institute, Inc.
(SAAMI). All warranties are
void if you use reloaded, remanufactured, handloaded,
or other non-standard ammunition.
3. Excessive pressure inside the chamber or the barrel
may cause severe damage to the rearm and/or severe
injury to the shooter. This may be caused by obstruc-
tions in the barrel, propellant powder overloads, or the
use of incorrect, wrongly assembled, dirty, corroded
or damaged cartridges.
4. Stop shooting IMMEDIATELY and check the barrel
for obstructions if:
- you have diculties in chambering a cartridge or
feel unusual resistance
- a cartridge misres
- a red cartridge case is not extracted
- you see unburned grains of powder in the mechanism
- a shot sounds abnormal or weak.
These obstructions may be caused by a bullet lodged
way down the barrel. Do not re another bullet in
the obstructed barrel as this may damage the er-
arm and cause serious injury to both the shooter
and bystanders.
5. Wipe any oil preservative from the chamber before
shooting and do not lubricate the cartridges. Lubri-
cants interfere with the required friction between
the cartridge case and the chamber wall. This
causes stress similar to excessive pressure.
6. Do not use too much lubricant on your guns moving
parts. Do not spray gun care aerosol products where
they may come into contact with ammunition. Do
not overspray. Lubricants, specially aerosol sprays,
may penetrate cartridge primers and cause the am-
munition to misre. Some lubricants may get inside
cartridge cases and prevent powder from igniting.
If only the primer ignites, the bullet may become
lodged in the barrel.
-
FIREARM CARE
1.
When your rearm is delivered it comes in a factory
package and has a light coating of protective grease
and oil. Clear all this grease and oil from the bore
and exposed mechanism before loading.
2.Double-check your rearm is unloaded before dis-
24