Instruction Handbook

MAINTENANCE.
It is recommended to clean and lubricate the pistol
every time it is red.
-
FIELD STRIPPING
Make sure the pistol is unloaded.
Depress the magazine release button and remove
the magazine. With right thumb rotate disassem-
bling latch until it stops (Fig. 7). Pull forward the
slide-barrel assembly with recoil spring and spring
guide (Fig. 8). Slightly pressing the recoil spring
guide head, lift the recoil spring guide (Fig. 9 and 10).
Take out the barrel from the slide.
No further disassembly is recommended unless
done by a competent gunsmith.
-
CLEANING AND LUBRICATING
After dismantling, clean the barrel and chamber
with a light lm of high quality gun oil to clean all
exposed internal surfaces. Put special attention on
the bolt face (where the ring pin protrudes) and
under the extractor hook. Lubricate moving parts
sparingly with a light high quality gun oil. Wipe o
any excess oil.
-
ASSEMBLY
Assemble following the Field Stripping procedure
in reverse order. It is advisable to pay attention to
the following points:
The recoil spring guide head should lodge in the
center of its groove in the barrel base.
When rotating the disassembling latch, the slide
should be in the closed position.
17