Manual

6
Dismantling after firing: Hold the pistol with the shooting hand (Figure 1). With the other hand, grasp
the grooved surface at the rear of the slide and pull it back. Press disassembly piece nr. 21 and the
slide will go back again to a second stop (Figure 2). Then lift the slide and pull (Figure 3).
Care and cleaning: After dismantling, clean the barrel and chamber thoroughly with bore solvent to
clean all exposed internal surfaces. Put special attention on the bolt face (where the firing pin pro-
trudes) and under the extractor hook. Lubricate moving parts sparingly with a light high-quality firearm
lubricant. Wipe off any excess oil.
Reassembly: Put the spring around the barrel. Hold the pistol with the shooting hand.
Keep the disassembly piece down (Figure 3), and release it.
Figure 1 Figure 2 Figure 3