Manual

13
pin of the grip. Remove the grip. Repeat the same procedure with the pin of the magazine release button
(Fig. 6) until it is dropped out. Put the magazine release button in the place of your preference following the
above procedures in reverse order. Then screw back the pin of the grip and reassemble it.
MAINTENANCE
It is recommended to clean and lubricate the pistol every time it is fired.
Field Stripping
Make sure the pistol is unloaded.
Depress the magazine release button and remove the magazine. With right thumb rotate disassembling
latch until it stops (Fig. 7). Pull forward the slide-barrel assembly with recoil spring and spring guide (Fig.
8). Slightly pressing the recoil spring guide head, lift the recoil spring guide (Fig. 9 and 10). Take out the
barrel from the slide
No further disassembly is recommended unless done by a competent gunsmith.
Cleaning and lubricating: After dismantling, clean the barrel and chamber with a light film of high quality
gun oil to clean all exposed internal surfaces. Put special attention on the bolt face (where the firing pin