Instruction Handbook

The weapon is ready for cleaning. No further disassem-

bly is recommended unless it is done by a competent

gunsmith.

CLEANING AND LUBRICATING

After dismantling, clean the barrel and chamber

thoroughly with solvent to clean all exposed inter-

nal surfaces. Put special attention on the bolt face

(where the ring pin protrudes) and under the ex-

tractor hook. Lubricate moving parts sparingly with

a light high quality gun oil. Wipe o any excess oil.

ASSEMBLY

Assemble following the Field Stripping procedure

in reverse order. It is advisable to pay attention that

the recoil spring guide head is centered on the front

face of the barrel base.

CAUTION: before assembling the slide, the sear must

be with it’s front part, lowered; if the trigger can

move completely forward, before assembling the

slide, insert an empty magazine, move thetrigger

back for lowering the sear, and then remove the

magazine.

(*) only for BP 9 CC and BP 40 CC models