Datasheet

ESD personal grounding set 5 pcs
9-361
content: see parts list below
ESD safe protection and workplace support for soldering and assembly
resistance 10^6 to 10^7 ohm (back side 10^3 to 10^4 ohm)
Platinum gray on top, black back of electrostatically dissipative synthetic rubber
with 2 press buttons 10 mm for ground connection
solder-resistant workplace pad with professional equipment for personal
grounding
heat-resistant, abrasion-resistant, scratch proof
extremely wear-resistant, permanently elastic, Halogen free
measures 900 x 610 x 2 mm
weight 1472 g
Area of application
Wrist grounding, as a safe method to derive electrostatic charge from people, consists of
an adjustable wrist strap with woven silver-plated plastic fibers (close skin contact
necessary) and a spiral cable, which connects the wristband with the earthing point via
press buttons, electrically dissipative. The coiled cable has a safety resistance of 1
MOhm on each connection side and is approved for workplaces with a rated voltage up
to 250 VAC.
Technical description
Products meet the requirements of DIN EN 61340-5-1. Specifications of the mat:
Abrasion (load: 5N) 130 mm³, hardness 78 Shore A, impression test 0.1 mm, light
reflectance 19% - 29%, temperature range of application up to + 60°C. Adjustable
elastic wristband with woven in silver-plated synthetic fibers, allergy-free. Meets the
safety requirements for wrist grounding according to BGFE. To ensure adequate
insulation, the bracelet may only be stored in a dry place. Washing instructions for the
bracelet: machine wash up to 30 ° C with soft washing powder, drying at low
temperature (warm not hot), do not bleach! Avoid contact with acidic / alkaline
solvents. ESD protection is retained for about 30 washing process.
General information
EPA suitable. For working in electrostatically protected areas (ESD workplace / ESD
protection zone).
1/2