Datasheet

ESD personal grounding set 5 pcs
9-360
content: see parts list below
ESD safe protection and workplace support for SMD / THT assembly
resistance 10^6 to 10^7 ohm (back side 10^3 to 10^4 ohm)
top and back side black electrostatically synthetic rubber
with 2 press buttons 10 mm for ground connection
solder-resistant work place pad with professional equipment for personal
grounding
heat-resistant, abrasion-resistant, halogen-free
extremely wear-resistant, permanently elastic
measures 900 x 610 x 1,5 mm
weight 1072 g
Area of application
Wrist grounding, as a safe method to derive electrostatic charge from people, consists of
an adjustable wrist strap with woven silver-plated plastic fibers (close skin contact
necessary) and a spiral cable, which connects the wristband with the earthing point via
press buttons, electrically dissipative. The coiled cable has a safety resistance of 1
MOhm on each connection side and is approved for workplaces with a rated voltage up
to 250 VAC.
Technical description
Products meet the requirements of DIN EN 61340-5-1. Specifications of the mat:
Abrasion (load: 5N) 130 mm³, hardness 80 Shore A, impression test 0.1 mm,
temperature range of application up to + 60°C. Adjustable elastic wristband with woven
in silver-plated synthetic fibers, allergy-free. Meets the safety requirements for wrist
grounding according to BGFE. To ensure adequate insulation, the bracelet may only be
stored in a dry place. Washing instructions for the bracelet: machine wash up to 30 ° C
with soft washing powder, drying at low temperature (warm not hot), do not bleach!
Avoid contact with acidic / alkaline solvents. ESD protection is retained for about 30
washing process.
General information
EPA suitable. For working in electrostatically protected areas (ESD workplace / ESD
protection zone).
1/2