Technical information

3
2
29
TRIGGERING THE
TRANSMITTER SIGNAL
EXITING THE
TEACHING MODE
automatically taught at the same
time.
The teach-in principle will now be
described based on an example
with the BLC radio button and
the RolloTec
®
radio button (see
below).
Deleting the assignment!
Teaching transmitter channel
again to an already assigned
receiver deletes the assignment.
The receiver signals this with a
rapidly pulsing tone or flashing
LED. The delete procedure must
be carried out separately for each
individual channel and light scene
button, and is acknowledged by
a rapidly pulsing tone or the pro-
gramming LED going out.
The delete procedure can be can
-
celled at any time by pressing a
button.
- Position transmitter in range of the receiv-
er (paying attention to reduced sensitivity)
and
- Trigger the desired transmitter channel.
The continuous tone in the receiver confirms
that the teaching procedure was successful.
- Press radio button again or
- wait 1 minute (programming mode is
exited automatically).
The receiver now responds to the transmit
-
ter function that has been taught.
- Repeat teaching procedure for each
transmitter.