Technical information

22222222
RADIO SHUTTER ACTUATOR
FLUSH-MOUNTED
This shutter actuator is built into
flush-mounted junction/switch
boxes or installed with splash-
protected junction boxes into
blind boxes. The end positions of
blinds/shutters can be integrated
into light scenes.
In order to implement master
and/or group control without
routing additional cables, a radio
shutter actuator flush-mounted
is installed for each drive and
controlled via a common radio
transmitter.
RADIO MOTION DETECTOR
POWER PACK SURFACE-MOUNTED
The radio motion detector power
pack surface-mounted is designed
for surface-mounting and primarily
evaluates signals from the radio
motion detector, but also those of
the other radio transmitters.
The triggering brightness threshold
is freely settable, as is the delay
time for the lighting.The operating
modes (ON/OFF for 2 hours) can
also be set.
The radio motion detector power
pack surface-mounted can process
signals from up to 30 radio trans-
mitter, which means that a building
can be monitored throughout by
multiple radio motion detectors.
RADIO SIGNAL AMPLIFIER
SURFACE-MOUNTED
The radio signal amplifier surface-
mounted is designed for surface-
mounting. It is used when the
transmission distance in a build-
ing is very long or the attenuation
is very high due to the construc-
tion materials used.
A radio signal amplifier surface-
mounted can receive the signal
from a taught-in radio transmit-
ter and forward it, thus doubling
the transmission distance in the
building.
GREAT COMPONENTS FOR EvERY AREA OF APPLICATION
THE RECEIVERS