Technical information

212121
RADIO CONTROL UNIT 1–10 V
BUILT-IN
The housing of this control unit is
designed to be built into hollow
spaces and intermediate ceilings,
and is used for switching and dim-
ming of electronic ballasts and
Tronic transformers with a 1–10 V
interface (e. g. fluorescent and
LV halogen lamps).
The control unit 1–10 V built-in
can can be integrated into light
scenes, and in addition the
switch-on brightness can be
saved.
RADIO SWITCH ACTUATOR
FLUSH-MOUNTED
The radio switch actuator flush-
mounted is suitable for installation
in flush-mounted or splash-pro-
tected junction/switch boxes. It
receives switching commands from
the taught-in radio transmitters and
triggers the remote switching of
mains-operated loads. The radio
switch actuator flush-mounted can
be integrated into light scenes, and
can be triggered via all radio trans-
mitters. This component is also
available as a radio push-button
actuator flush-mounted (e. g. for a
garage door controller or expansion
of a stair light controller).
RADIO SWITCH ACTUATOR
2GANG FLUSH-MOUNTED
This switch actuator is built into
flush-mounted or splash-pro-
tected junction/switch boxes. In
conjunction with a taught-in radio
transmitter, remote switching of
mains-operated loads is possible
divided between two channels.
That makes this actuator particu
-
larly suitable for transforming an
existing switch-off into a series-
parallel connection without having
to route additional cables.
The radio switch actuator 2gang
flush-mounted can be integrated
into light scenes.