Technical information

202020
RADIO SHUTTER ACTUATOR RMD
A radio shutter actuator RMD is
built into the distribution box for
each drive. This receives signals
from the taught-in transmitters
(max. 14) via the radio receiver
RMD and switches mains-oper
-
ated tubular motors. The end
positions of blinds/shutters can
be integrated into light scenes.
In order to implement master and/
or group control without routing
additional cables, a radio shutter
actuator RMD is installed for each
drive and controlled via a common
transmitter.
RADIO SWITCH ACTUATOR
BUILT-IN
Thanks to their relay output stage
these radio switch actuators are
suitable for switching larger loads.
Their housings are designed for
installation in hollow spaces and
intermediate ceilings. Switching
commands of taught-in radio trans-
mitters are detected, and trigger
switching of the connected load.
A radio switch actuator built-in can
be integrated into light scenes, and
also has an extension unit input for
a push-button. This component is
also available as a radio push-but-
ton actuator built-in (e. g. for garage
door or stair light controllers).
RADIO UNIVERSAL DIMMER
BUILT-IN
The housing of the radio univer
-
sal dimmer built-in is designed to
be built into hollow spaces and
intermediate ceilings.The univer
-
sal dimmer automatically detects
the connected load. Switching
and dimming commands from the
taught-in radio transmitters are
received and change the bright-
ness. A saved brightness value is
set again after switching on with a
bulb-preserving soft startup. The
radio universal dimmer built-in can
be integrated into light scenes.
GREAT COMPONENTS FOR EvERY AREA OF APPLICATION
THE RECEIVERS