Technical data

4. Press out 2 idler shafts (3375-0669) using a 1/2″ arbor press. Exert steady, firm pressure until the shafts drop
through. Catch the shafts with your hand so they will not be damaged by dropping on a hard surface.
5. Press out the drive-gear assembly shaft (4375-0132) from the back side of the gear box (the side opposite
the housing), complete with gears, using a 5/8″ diameter arbor press.
NOTE
On occasion the back bearing will break loose and drop with the assembly into
the housing. In that case you will have to wait until the housing halves are sepa-
rated before the bearing is removed from the shaft.
S6151-DL-MMM-010
1-21