Technical data

SERVICE NOTE: On some Assemblies you may find a thin metal shim washer. If new spacers are used,
you will probably NOT have to use this shim washer.
B. BLADE SHAFT ASSEMBLY REPLACEMENT (4575-0059 front, 4575-0061 rear) The blade shaft assem-
bly should only have to be replaced if the gear teeth or shaft have been damaged.
1. Disassemble blades and spacers as described in previous section.
2. Replace a new shaft (front or rear).
NOTE
a. Notch on first blade placed must match slot in shaft, and;
b. Blade incline must be the same direction as the incline of the gear teeth.
3. Reassemble blades and spacers as described in previous section.
C. BLADE FRAME ASSEMBLY Any part of the Blade Frame Assembly can be replaced if damaged or bro-
ken. (Consult accompanying picture and line drawing on page 26.
S6151-DL-MMM-010
1-9