Technical data

CHAPTER 1

Unpacking and Installation

1. Lay tenderizer on it’s back onto a thick layer of cloth. Remove the shipping studs from base.

2. While in this position install the 4 studs from the small carton and wrench tighten . Also snap on the 4 rub-

ber feet.

3. Set tenderizer up on legs, remove shipping tape that holds safety neck in place and tip safety neck back.

4. Lift the tenderizer assembly by gripping the knife frame guides in the center, with drive clutches to your left.

Lower the tenderizer assembly into the front of the machine until it rests ﬁrmly on the 4 support pins. Slide

unit to the left, which engages the clutches.

S6151-DL-MMM-010

1-1