Operation Manual

ManualsBrandsBergamont ManualsBicycle E-bikeMTB - Pedelec

60 61

MTB-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2016

ORIGINAL OPERATING INSTRUCTIONS 2016 | MTB-PEDELEC

b ca e fd

ENGLISH

Tighten the bolts evenly and in a cross pattern, i.e. alternately and gradually, to

the lower value of the recommended torque values using a torque wrench.

Once clamped in the stem try rotating the handlebars and tighten the bolt a

little more, if necessary. Use a torque wrench and never exceed the maximum

torque values! You find them directly on the components and/or in the manuals

of the component manufacturers on this BERGAMONT info CD. If the handle-

bars are not tight with the prescribed torque value, use carbon assembly paste.

After adjusting the handlebars you need to adjust the brake lever/shifter units.

Release the Allen bolt at either unit. Turn the levers relative to the handlebars.

Sit in the saddle and place your fingers on the brake levers.

Check whether the back of your hand forms a straight line with the line of your

forearm (f). Retighten the units with a torque wrench and do a twist test! The

brake levers need not be absolutely tight. In case of a fall it is an advantage

when the brake levers can be turned.

DANGER!

Tighten the bolts at the stem until the clamping slots between the stem

body and the faceplate are parallel and identical in width at the top and at

the bottom. Tighten the bolts evenly and in a cross pattern, i.e. alternately and

gradually, to the lower value of the recommended torque values using a torque

wrench.

DANGER!

Note that the bolted connections of the stem, handlebars, bar ends

and brakes have to be turned to their prescribed torque values. Use a

torque wrench and never exceed the maximum torque values! You will find

the prescribed values in the chapter “Recommended torque settings for your

BERGAMONT bike”, directly on the components and/or in the manuals of the

component manufacturers on this BERGAMONT info CD.

Hydraulic brakes are also fitted with adjusting devices at the brake lever (a).

There are different systems. Ask your BERGAMONT dealer for advice or read

the manuals of the component manufacturers on this BERGAMONT info CD.

When adjusting the lever reach, make sure the first phalanx of the index finger

reaches around the brake lever (b). Check the proper adjustment and function-

ing of the brake system subsequently, as described in the chapter “Brakes” and

in the manuals of the component manufacturers on this BERGAMONT info CD.

DANGER!

Make sure your child cannot pull the brake levers all the way to the handle-

bars. Your maximum braking force must be reached short of this point.

NOTE!

In the case of hydraulic brakes and disc brakes follow the manual of the

brake manufacturer, which you can find on this BERGAMONT info CD. If you

are in doubt or if you have any questions, contact your BERGAMONT dealer.

Adjustment of handlebar tilt and brake levers on BERGAMONT

mountain bikes

The handlebars are usually slightly bent at the ends. Set the handlebars to a

position in which your wrists are relaxed and not turned outwards too much (c).

Release the Allen bolt(s) at the bottom or front side of the stem.

Turn the handlebars to the desired position.

Make sure the handlebars are accurately centred in the stem (d). Carefully

retighten the bolt(s) with the torque wrench. Make sure the upper and lower

clamping slots of the stem are parallel and identical in width (e).