User Manual

• Remove the Beretta Microcore recoil pad from the stock.

• Use the 13-mm tube wrench to completely unscrew the retaining nut of the

stock and remove the nut, spring washer and plate .

• Separate the stock from the receiver and remove the plate .

REASSEMBLY

• Centre the front spacer  on the stock bolt tube. Make sure that the indicator

showing the desired drop and cast (“C-60-DX” in the diagram) is visible on

the spacer.

• Reposition the stock. Place the rear plate  inside the stock. Make sure that

the same marking is visible on the plates.

• Use the 13-mm tube wrench to insert the retaining nut of the stock and spring

washer and tighten down with tightening torque 1.6 - 1.8 Kgm (Kilogram-

meters). The use of a proper dynamometric wrench is recommended.