User Manual

ENGLISH

Juice Extractor Use instructions

DESCRIPTION OF THE COMPONENTS

1 - Presser

2 - Lid

3 - Centrifugal lter

4- Filter base

5- Locking tabs

6- Juice container

7- Pulp container

8- Motor base

9- ON/OFF switch

10- Non-slip feet

11- Power cord

12- Power cord housing

USE OF THE ELECTRIC HOUSEHOLD APPLIANCE FOR THE FIRST TIME

After you have removed the centrifuge from the wrapping you have to wash all the components,

except for the basis of the motor in warm and soaping water.

ATTENTION: not wash the centrifugal lter in your washing machine because it could demage the

stainless thin retina

Don’t ever bath the basis of the motor in water but clean it with a damp cloth.

DISASSEMBLY AND REASSEMBLY OF THE CENTRIFUGE

Release the locking tabs by pulling the lower part upwards.

Remove the lid. Lift the centrifugal lter and the pulp container.

Remove the juice container and rinse it with running water

To reassemble the components of the centrifuge, place the power cord into its housing, then repo-

sition the pulp container on the motor base and the centrifugal lter in its housing. Ensure that this

has been completely tted in place.

Rest the lid on the Pulp container and hook the locking tabs by pressing them slightly, as shown in

the

gure. Reinsert the juice container in its special seat.

INSTRUCTIONS FOR USE

Run the door of the opening wind-cable to the top and take the feeding cable out of its seat.

Verify that the tension of the device correspond to that of your system (see the technical data em-

bossed plate). Insert the plug of the feeding cable in the current tap. Push the switch to start the

CENTRIFUGE. Even the light lit up.

Pull out the presser. Introduce the food which has been previously cut into small pieces, deprived

of the stones and other tough and brous parts which cannot be centrifuged. Afterwards, slightly

press in the food by means of the presser. Never use your ngers to push the food. Food can be

introduced continually into the ller hole without turning off the motor.