User's Guide
Table Of Contents
To modify gateways:
1. Open the RangerPro configuration application.
2. Select Network Manager >Gateways. Existing gateways are displayed.
o
To modify a gateway:
a. Select the gateway and click Modify. The Modify Gateway dialog box is
displayed.
b. Modify the Site Name or Gateway Name.
c. Click Modify Gateway.
o
To remove a gateway:
a. Select the gateway and click Remove. The Remove Gateway dialog box is
displayed.
b. Click Remove Gateway.
o
To reset gateways:
a. Select an individual gateway and click Reset.
b. Click Reset All.
To view available devices on the gateway:
1. Open the RangerPro configuration application.
2. Select Network Manager >Gateways. Existing gateways are displayed.
3. In Gateways, select a gateway from the list.
4. Double-click on the gateway name. The Sensors pane displays all devices and their status.
If using System 1, to modify the gateway IPaddress, refer to the System 1 online help or user
guide.
Configure Sensors Over the Network
To configure sensors over the network:
1. Open the RangerPro configuration application.
2. Select Network Manager >Sensors tab. Current devices are displayed.
3. Select Configuration Manager >Live Configuration.
4. Select a sensor device. Verify that the sensor status in the application footer is Ready.
5. Modify configuration options as needed.
6. Unsaved changes are highlighted in blue. To save the changes, click Apply. Pending
changes are displayed in orange. Completed changes are displayed in black.
To save sensor configuration settings:
1. Open the RangerPro configuration application.
2. Select Network Manager >Sensors. Current devices are displayed.
29/57
Ranger Pro Wireless Condition Monitoring Device
User Guide 125M6113 Rev. F