User manual

APPENDIX BFAULT CODES
Fault Codes
196
APPENDIX B - FAULT CODES
Fault Code Description Controlled Fault Stop Shunt Trip Fault Auto-Reset Allowed
F00 No fault - - -
F01 UTS Time Limit Expired Y N Y
F02 Motor Thermal Overload Trip Y N Y
F03 Slow Speed Time Limit Expired N N N
F10 Phase Rotation Error, not ABC N N Y
F11 Phase Rotation Error, not CBA N N Y
F12 Low Line Frequency N N Y
F13 High Line Frequency N N Y
F14 Input power not single phase N N Y
F15 Input power not three phase N N Y
F21 Low Line L1-L2 Y N Y
F22 Low Line L2-L3 Y N Y
F23 Low Line L3-L1 Y N Y
F24 High Line L1-L2 Y N Y
F25 High Line L2-L3 Y N Y
F26 High Line L3-L1 Y N Y
F27 Phase Loss N N Y
F28 No Line N N Y
F30 I.O.C. N Y N
F31 Overcurrent Y N Y
F34 Undercurrent Y N Y
F37 Current Imbalance Y N Y
F38 Ground Fault N Y Y
F39 No Current at Run N N Y
F40 Shorted / Open SCR N Y N
F41 Current at Stop N Y N
F46 Disconnect Fault N Y N
F47 Stack Protection Fault (stack thermal overload) N N Y
F48 Bypass/2M Contactor Fault Y N N
F49 Inline Contactor Fault Y N N
F50 Control Power Low N N Y
F51 Current Sensor Offset Error N Y N
F54 BIST Fault N N N
F55 BIST CT Fault N N N
F60 External Fault on DI 1 Input N N Y
F61 External Fault on DI 2 Input N N Y
F62 External Fault on DI 3 Input N N Y
F71 Analog Input #1 Level Fault Trip Y N Y
F81 Keypad Communication Fault Y N N
F82 Modbus Timeout Fault Y N Y
F94 CPU Error – SW fault N N N
F95 CPU Error – Parameter EEPROM Checksum Fault N N N
F96 CPU Error N Y N
F97 CPU Error - SW Watchdog N Y N
F98 CPU Error N N N
F99 CPU Error – Program EPROM Checksum Fault N N N