Technical information

3 – KEYPAD OPERATION
Remote LCD Keypad and Display
22
3.3.3 Alphanumeric Display
The remote LCD keypad and display uses a 32-character alphanumeric LCD display. All starter functions can be accessed by the
keypad. The keypad allows easy access to starter programming with parameter descriptions on the LCD display.
Power UP Screen
On power up, the software part number is displayed for a few seconds. Pressing any key immediately changes the display to the
operate screen.
Software PN
810018-01-00
NOTE: The software part number may be different than that shown above.
Operate Screen
The operate screen is the main screen. The Operate screen is used to indicate the status of the starter, if it’s running, what state it’s in,
and display the values of Meter 1 and Meter 2, which are selectable.
SSAAAAAACCCCCCCC
BBBBBBBBDDDDDDDD
The Operate Screen is divided into four sections.
• Sections A and B display status information
• Section C and D displays the meter selected by the Meter 1 and 2 parameters.
• Section SS displays the source for the start command.
Table 4 – Operate Screen Section A
Display Description
noL L1, L2, L3 not present
Ready Starter ready to run
Alarm A fault condition is present. If it continues, a fault to occurs
Run Starter is running
Table 5 – Operate Screen Section B
Display Function
Stopped Starter is stopped and no Faults
Lockout Starter is in the Lockout condition
Fault Starter tripped on a Fault
Heater Starter is on and heating motor
Kick Starter is applying kick current to the motor
Accel Starter is Accelerating Load
Kick 2 Starter is applying kick current to the motor
Accel 2 Starter is Accelerating Load
Run Starter is in Run mode
UTS Starter is Up To Speed
Control Phase Control or Current Follower mode
Decel Starter is Decelerating Load
Wye In Wye-delta control indicates motor is accelerating in Wye
mode
Table 6 – Operate Screen Section SS
K Keypad
T Terminal Block Wiring
S Serial Communication Connection