Declaration of Conformity

FCC SDoC: Visit www.benq.com/en-us > Support > the purchased model > the User
Manual tab to access the SDoC (Supplier’s Declaration of Conformity) document. You may
not nd your product’s SDoC document online as it was not required at the time the
product was manufactured. However, it does not change the fact that the product has been
tested to comply with FCC standards, as indicated by the FCC logo on the product or on the
label.
IC statement (for Canadian users)
This Class B digital apparatus complies with Canadian ICES-003(B).
Cet appareil numérique de la classe A est conforme à la norme NMB-003(B) du Canada.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Important note:
Radiation Exposure Statement
Model Name: WDC20TC
IC: 6175A-WDC20TC
FCC RF Radiation Exposure Statement Caution: This device
complies with FCC’s radiation exposure limits set forth for an
uncontrolled environment”.
FCC RF exposure information (SAR)
This device meets the government's requirements for exposure
to radio waves. This device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the
U.S. Government.
The exposure standard for wireless devices employs a unit of
measurement known as the Specic Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions accepted by the
FCC with the device transmitting at its highest certied power
level in all tested frequency bands. Although the SAR is
determined at the highest certied power level, the actual SAR
level of the device while operating can be well below the
maximum value. This is because the device is designed to operate
at multiple power levels so as to use only the poser required to
reach the network.
In general, the closer you are to a wireless base station antenna,
the lower the power output. While there may be differences
between the SAR levels of various devices and at various
positions, they all meet the government requirement.
Model Name: WDC20R
IC: 6175A-WDC20R
This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
Cet équipement doit être installé et utilisé à distance minimum de
20cm entre le radiateur et votre corps.
FCC Caution: Any changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
FCC RF exposure information (SAR)
Radiation Exposure Statement
Model Name: WDC20TC
FCC ID: JVPWDC20TC
FCC RF Radiation Exposure Statement Caution: This device
complies with FCC’s radiation exposure limits set forth for an
uncontrolled environment”.
FCC RF exposure information (SAR)
This device meets the government's requirements for exposure
to radio waves. This device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the
U.S. Government.
The exposure standard for wireless devices employs a unit of
measurement known as the Specic Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions accepted by the
FCC with the device transmitting at its highest certied power
level in all tested frequency bands. Although the SAR is
determined at the highest certied power level, the actual SAR
level of the device while operating can be well below the
maximum value. This is because the device is designed to operate
at multiple power levels so as to use only the poser required to
reach the network.
In general, the closer you are to a wireless base station antenna,
the lower the power output. While there may be dfferences
between the SAR levels of various devices and at various
positions, they all meet the government requirement.
La conformité du SAR a été établie dans un ou plusieurs
bloc-notes typiques avec une fente USB, et le produit peut être
utilisé dans un bloc-notes typique avec une fente USB. D’autres
applications telles que les PC de poche ou les appareils similaires
n’ont pas été vériées et peuvent ne pas être conformes aux
règles d’exposition aux radiofréquences et leur utilisation est
interdite.
Model Name: WDC20R
FCC ID: JVPWDC20R
This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
Cet équipement doit être installé et utilisé à distance minimum de
20cm entre le radiateur et votre corps.
Caution:
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
(ii) The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and
5470-5725 MHz shall comply with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall
comply with the e.i.r.p. limits specied for point-to-point and non point-to-point operation as
appropriate.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250 - 5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.