User's Manual

13
FCC statement (for the United States only)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
FCC RF exposure information (SAR)
Radiation Exposure Statement
Model Name: WDC20TH
FCC ID:JVPWDC20TH
SAR compliance has been established in typical laptop computer(s) with USB
slot, and product could be used in typical laptop computer with USB slot.
Other application like handheld PC or similar device has not been verified and
may not compliance with related RF exposure rule and such use shall be
prohibited.
Model Name: WDC20R
FCC ID:JVPWDC20R
This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
Caution:
(i) the device for operation in the band 5150 - 5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems; (ii) the maximum
antenna gain permitted for devices in the bands 5250 - 5350 MHz and 5470 - 5725 MHz shall
comply with the e.i.r.p. limit.
(iv) Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250 - 5350 MHz and 5650 - 5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
FCC SDoC: Visit www.benq.com/en-us the purchased model > the Support tab > the User Manual tab to access the
SDoC (Supplier’s Declaration of Conformity) document. You may not find your product’s SDoC document online as it was
not required at the time the product was manufactured. However, it does not change the fact that the product has been
tested to comply with FCC standards, as indicated by the FCC logo on the product or on the label.