User's Manual

25 Installation
2. Connect the USB 3.0 connector on the Button to a powered on laptop and wait for at least 30
seconds.
3. Poke the RESET hole at the bottom of the Button with a pin for at least 2 seconds.
4. The Button LED will begin quick flashing red (flash red twice every second) for 10 seconds, then
light up static red for 15 to 20 seconds, indicating that the Button is resetting.
5. Once the Button LED lights up static green the resetting process is complete.
After the Button has been connected to a powered on laptop for at least 30 seconds, the Button LED may
indicate any one of the statuses described in
LED indicators of the Button and Host. As long as the Button has
been connected to a powered on laptop for at least 30 seconds, you may proceed to the next step of the
resetting process regardless of the status of the Button
LED.
Do not disconnect the Button from its power source at any time during the resetting process.