User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Starting and stopping presentations
- Troubleshooting
- copyight.pdf
21 Installation
Pairing a Button and Host
The product includes an Host and two Buttons, which are paired before shipment. In such a case, you
don’t need to pair them again. However, if you buy two or more sets of InstaShow™ S, and you want
to pair a Button with a different Host, you need to follow the instruction below. If you buy an
additional Button Kit, and you want to pair the new Buttons with your Host, you need to follow the
instruction below as well.
When the Host is placed on a table
1. Make sure your Host is ready with power supply. Connect the Button’s HDMI and USB jacks to
the corresponding inputs of a laptop.
2. When the Button is connected to the laptop, the LED indicator of the Button will flash red. The
Button is in pairing mode, waiting to pair with your Host.
If a Button nearby has been paired with a Host before, it will turn static green.
USB
3.0
HDMI
1.4