User's Manual

18 Installation
LAN connection
The Host can be connected to a local network or directly to a laptop. The LAN connection can be
used to configure the product and update the software. Insert a network cable with RJ-45
connectors into the LAN port and connect the other side to a LAN.
Setting up and powering a Button
1. Connect the Button’s HDMI and USB jacks to the corresponding inputs of a laptop. See the illus-
tration.
2. The LED indicator of the Button will flash green while the Button is starting up.
3. When the button is ready to present, the LED indicator will turn solid green. Press the Present
key when the LED indicator turns green.
• If the button encounters problems while pairing with the Host during startup the LED indicator will flash red.
Repeat the previous the process again until the LED turns solid green. See LED indicators of the Button and
Host on page 8
for more information on LED behavior.
• Handle the Button cable with care. Rough handling might cause defects.
• Pull/Push the plug instead of the cable when inserting or removing Buttons.
USB
3.0
HDMI
1.4