User's Manual

9 Installation
Installation
This section will guide you on how to prepare the unit before its initial use.
Environment check
Before installing the product, check the environmental conditions.
1. Do not install the device near heat sources like radiators or direct sunlight, or in a site with
excessive dust or humidity.
2. Ambient temperature conditions are listed as below. Maximum ambient temperature should be
+40°C or 104°F. Minimum ambient temperature should be +0°C or 32°F. Storage temperature
should be -10°C to +60°C (14°F to 140°F).
3. Humidity conditions are listed as below. For storage, the relative humidity should be 5% to 90%
(non-condensing). For operation, the relative humidity should be10% to 80% (non-condensing).
As the product works with different displays, the steps required to complete the installation may vary
according to the actual environment and your display specifications. Follow the procedures below and
refer to the specified sections for details.
1. Assemble the Host with the antennas. See
Assembling the Host on page 10 for details.
2. Connect the Host to the display and power properly. See
Connecting the HDMI cable and
power on page 15
for details. Four installation methods are provided.
• Attaching the Host to the ceiling
• Attaching the Host to a ceiling mount
• Placing the Host on a table
• Installing the Host on the wall or trolley
3. Connect the Button to the desired devices and power properly. See
Setting up and powering a
Button on page 18 for details.
4. Make sure that all the connected devices have been powered on. Press the source button of the
display and make sure that the HDMI source has been transmitted. See Pairing a Button and
Host on page 21 for details.