User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
58 Web management
To upgrade the InstaShow Button Driver ensure that both the InstaShow Host and InstaShow Button
are properly connected and the LEDs on both devices are static green, then follow the steps below:
1. Press Browse and choose the file to upgrade.
2. Choose the InstaShow Button that needs to be updated. Each InstaShow Button has a different
Mac address, check the spec label and choose the Mac address of the InstaShow Button.
3. Press Driver Upgrade to proceed.
To upgrade the InstaShow Host Driver, ensure that both the InstaShow Host and InstaShow Button
are properly connected and the LEDs on both devices are static green, then follow the steps below:
1. Press Browse and choose the file to upgrade.
2. Press Driver Upgrade to proceed.
To upgrade the InstaShow Button firmware, ensure that both the InstaShow Host and InstaShow
Button are properly connected and the LEDs on both devices are static green, then follow the steps
below:
1. Press Browse and choose the file to upgrade.
S/N : WDX210001203G
MAC: 000EA000B90D
R
InstaShow Button
Model Name: WDC10TC
P/N: 5J.JLD28.E10
Power Rating: 5V 0.9A
Made in Taiwan
1
3
2
1
2