User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
53 Web management
The InstaShow Host will enter Network Standby Mode under the following conditions:
• The InstaShow Host has broadcast the Guide screen or Idle screen for the amount of time set in
the Standby Mode field. In this circumstance the connected display will usually enter standby or
power saving mode after a set period of time based on the configured settings for the display.
The InstaShow Host will wake up from Network Standby Mode under the following conditions:
• A wireless connection is made between the InstaShow Host and an InstaShow Button (the LEDs on
both the InstaShow Host and InstaShow Button are lit up static blue).
HDMI Standby Mode, places the InstaShow Host in standby mode if there is no HDMI signal/
connection to the InstaShow Host for at least 10 minutes. When the InstaShow Host is in HDMI
Standby Mode the LED will be off and power consumption will be less than 0.5W.
The InstaShow Host will enter HDMI Standby Mode under either one of the following conditions:
• No HDMI cable connection is made between the InstaShow Host and a display for at least 10
minutes.
• The display which is connected to the InstaShow Host is powered off for at least 10 minutes.
The InstaShow Host will wake up from HDMI Standby Mode under either one of the following
conditions:
• The display which is connected to the InstaShow Host is powered on.
• The power button on the InstaShow Host is pressed.
• The power cable connected to the InstaShow Host is disconnected then reconnected.
After you configure all the Advance Setting items, press Apply to proceed.
• In cases where users want to conserve energy, Network Standby Mode is a suitable mode as the power
consumption for a display (e.g. projectors, TVs, monitors, etc.) is usually greater than the power consumption
for the InstaShow Host (5V/1.5A).
• In cases where the InstaShow Host is attached to a ceiling or the power button is out of reach by the user,
HDMI Standby Mode is a suitable mode as it allows the user to power off the InstaShow Host by powering
off the display.