User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
49 Web management
Advance Setting
Click Advance Setting to adjust Picture Quality Mode, Frame Rate, Screen Lock, EDID
Management, and Standby Mode.
You can change mode to Presentation mode, Video mode, and Low Power via Picture Quality
Mode. The default mode is Presentation mode. Be aware that after the firmware is upgraded to
v2.01, the default mode will be changed to Video mode. The mode set by Picture Quality Mode
in web management is the default mode next time when the InstaShow host restarts. That is, if the
mode is Video mode and is switched to Presentation mode by the InstaShow button while playing
files, the mode will remain Video mode next time the host restarts. A description for the scenarios
that are suitable for each mode is described below:
Mode Scenario
Presentation mode For use when highly detailed visuals are necessary.
Video mode For use when smooth video playback is necessary.