User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
47 Web management
2. When the InstaShow Button is successfully connected to the laptop, the LED indicator of the
InstaShow Button will blink red.
3. Make sure the InstaShow Host is properly connected to a power source.
4. Press start pairing to pair the InstaShow Host to the InstaShow Button via the web
management interface, you will have two minutes to pair with the InstaShow Button.
5. Press the MODE key on the side of the InstaShow Button for five seconds. The LED indicator
of the InstaShow Button will blink blue for about 10 seconds. The pairing process is ongoing. A
“Pairing” message will be shown on the screen.
MODE
00:00:00
00:00:05
pairing...