User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
46 Web management
Pairing
Click Pairing and you will see Pairing and Pairing Status.
Pairing is used when the InstaShow Host is attached to the ceiling as it is not easy to press the
PAIRING key of the InstaShow Host when the device is high on the ceiling. You can pair a InstaShow
Button and InstaShow Host via the web management interface. See Advance Setting on page 49 for
more information about EDID status.
1. Connect the InstaShow Button’s USB-C™ jack to the corresponding port of a laptop.
USB-C™
MODE