User's Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
44 Web management
example, changing Tra n s m i ss i o n Powe r from 1 to 2 can increase the signal strength around 2 dBm
in real measurement.
In Channel, you can configure the InstaShow Host to automatically select the wireless channel with
the best performance during the initial setup of the InstaShow Host by selecting Auto, or you can
select a wireless channel manually. The default Channel setting for the InstaShow Host is Auto.
In cases when the broadcast of a presentation is unstable or choppy, due to interference to the
wireless connection between the InstaShow Host and InstaShow Button from other wireless devices
in the area, users can switch the Channel by pressing Rescan. By pressing Rescan the InstaShow
Host will switch to the wireless channel with the best performance and least interference at the time.
• After pressing Rescan, the broadcast of the presentation will be interrupted for a few seconds and the LED on
the InstaShow Host will flash red then light up static green. Press the Present key on the InstaShow Button
afterwards to resume the presentation.
• Supported wireless channels listed may vary according to wireless regulations of the country/region.