W100 Digital Projector Home Entertainment Series User's Manual

Maintenance

14. Resetting the lamp counter

Do not reset if the lamp is not replaced as this could cause damage.

i. Press and hold the EXIT button on the projector for 5 seconds to

display the total used lamp time.

ii. Press AUTO on the projector or on the remote control to reset the

lamp hour to “0”.

iii. Wait about 5 seconds to let the OSD disappear.

Temperature information

When the Temperature warning light is on, it is warning you of the following possible problems:

1. The internal temperature is too high.

2. The fans are not working.

Turn the projector off and contact qualified service personnel for further help. For more information, please

refer to "Indicators" below.

Indicators

Illustration

•Blank - : Light OFF • O : Orange light

• : Light flashing

• R : Red light

• : Light ON

• G : Green light

Light Status & Description

Power Temp Lamp

Power events

Stand-by mode.

The Power indicator light is flashing during powering up.

The projector is under normal operation.

1. The projector needs 90 seconds to cool down as it was abnormally shut

down without the normal cooling down process. Or

2. The projector needs to cool for 90 seconds after the power is turned

off.

The projector has shutdown automatically. If you try to re-start the

projector, it will shutdown again. Please contact your dealer for assistance.