Operation Manual
Table Of Contents
- Table of contents
- Important safety instructions
- Overview
- Positioning your projector
- Connecting to video equipment
- Using the projector
- Turning the projector on
- Selecting an input source
- Using the menus
- Securing the projector
- Adjusting the projected image
- Using the preset and user modes
- Fine-tuning the picture quality
- Advanced picture quality controls
- Selecting the aspect ratio
- Setting a wall color
- Hiding the image
- Locking control keys
- Freezing the image
- Adjusting the sound
- Using the test pattern
- Using the teaching templates
- Setting the lamp mode
- Controlling the projector through a Wired LAN environment
- Operating in a high altitude environment
- Turning the projector off
- On-Screen Display (OSD) menus
- Additional information
- Warranty and Copyright information
34
Using the projector
English
Fine-tuning the picture quality
No matter what picture mode you have selected, you are able to fine-tune those settings to fit every
presentation purpose. Those adjustments will be saved to the preset mode you are at when you exit the
OSD menu.
Adjusting Brightness
Highlight Brightness in the Picture menu and adjust the
values by pressing / on the projector or remote
control.
The higher the value, the brighter the picture. And the
lower the setting, the darker the picture. Adjust this
control so the black areas of the picture appear just as black and that detail in the dark areas is visible.
Adjusting Contrast
Highlight Contrast in the Picture menu and adjust the
values by pressing / on the projector or remote
control.
The higher the value, the greater the contrast. Use this to
set the peak white level after you have previously adjusted
the Brightness setting to suit your selected input and viewing environment.
Adjusting Color
Highlight Color in the Picture menu and adjust the values by pressing / on the projector or
remote control.
Lower setting produces less saturated colors; setting to the minimum value makes the image black and
white. If the setting is too high, colors on the image will be overpowering, which makes the image
unrealistic.
Adjusting Tint
Highlight Tint and adjust the values by pressing / on the projector or remote control.
The higher the value, the more greenish the picture becomes. The lower the value, the more reddish the
picture becomes.
Adjusting Sharpness
Highlight Sharpness and adjust the values by pressing /
on the projector or remote control.
The higher the value, the sharper the picture becomes. The
lower the value, the softer the picture becomes.
The Brightness, Contrast functions can also be accessible by pressing
BRIGHTNESS, CONTRAST on the remote control to display the
adjustment bar and then you can press / to adjust the values.
30 50 70
30 50
70
357