Operation Manual
Table Of Contents
- Table of contents
- Important safety instructions
- Overview
- Positioning your projector
- Connecting to video equipment
- Using the projector
- Turning the projector on
- Selecting an input source
- Using the menus
- Securing the projector
- Adjusting the projected image
- Using the preset and user modes
- Fine-tuning the picture quality
- Advanced picture quality controls
- Selecting the aspect ratio
- Setting a wall color
- Hiding the image
- Locking control keys
- Freezing the image
- Adjusting the sound
- Using the test pattern
- Using the teaching templates
- Setting the lamp mode
- Controlling the projector through a Wired LAN environment
- Operating in a high altitude environment
- Turning the projector off
- On-Screen Display (OSD) menus
- Additional information
- Warranty and Copyright information
21
Connecting to video equipment
English
Connecting video devices
The audio connections are provided for informational purposes only. You can also connect the separate
audio cable to a suitable audio amplifier.
• If you have already made a Component Video connection between the projector and the video source
device, you need not connect to this device again using a composite Video connection as this makes an
unnecessary second connection of poorer picture quality.
• If the selected video image is not displayed after the projector is turned on and the correct video source
has been selected, please check that the video source device is turned on and operating correctly. Also
check that the signal cables have been connected correctly.
or
AV equipment
Speakers
Video cable
Audio cable
Audio cable