User Manual

Preparation6
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press to highlight DHCP and press / to select Off.
3. Contact your network administrator for information on the IP Address, Subnet
Mask, Default Gateway, and DNS settings.
4. Press to select the item you want to modify and press MODE/ENTER.
5. Press / to move the cursor and the press / to enter the value.
6. To save the settings, press MODE/ENTER. If you do not want to save the settings,
press MENU/EXIT.
7. Press to highlight Apply and press MODE/ENTER.
After the above steps, your projector is now connected to your local area network and
ready to be accessed by any computer on the same local area network.
Alternatively, to check the IP address of your projector, make sure the projector is connected to the Internet,
and press SOURCE on the projector. Select Network Display. The IP address is displayed on the screen.