Owners manual

Operation 57
Description of each menu
• The default values listed in this manual, especially on pages 57-66, are
for reference only. They may vary between the projectors due to the
continuous improvement to the products.
FUNCTION DESCRIPTION
Wall Color
Corrects the projected picture’s color when the projection
surface is not white. See "Using Wall Color" on page 41 for
details.
Aspect Ratio
There are four options to set the image's aspect ratio depending
on your input signal source. See "Selecting the aspect ratio" on
page 38 for details.
2D Keystone
Corrects vertical and horizontal keystonings of the image. See
"Correcting 2D keystone" on page 30 for details.
Corner Fit
Manually adjust four corners of the image by setting the
horizontal and vertical values. See "Adjusting corner fit" on page
31 for details.
Position
Displays the position adjusent page. To move the projected
image, use the directional arrow keys. The values shown on the
lower position of the page change with every key press you made
until they reach their maximum or minimum.
This function is only available when a PC signal
(analog RGB) is selected.
Phase
Adjusts the clock phase to reduce image
distortion.
This function is only available
when a PC signal (analog RGB) is selected.
H. Size
Adjusts the horizontal width of the image.
This function is only available when a PC signal
(analog RGB) is selected.
Digital Zoom
Magnifies or reduces the projected image. See "Magnifying and
searching for details" on page 37 for details.
1. DISPLAY menu