User's Manual
Table Of Contents
- BenQ.com
- Disclaimer
- FCC regulations
- Package contents
- Front-right view
- Left side view
- Rear view
- Installing the battery
- Turning the device on/off
- Using the touchscreen
- Using Touch zone
- Basic setup
- Setting time
- Setting BenQUtility
- 1. To launch it you can go to Programs > BenQUtility.
- 2. Tap On in WLAN/Bluetooth.
- Using WLAN
- 1. Tap and drag the scroll box of WLAN to On in BenQUtility.
- 2. Setup the WLAN access point according to the information provided by your ISP. You may be requested to enter a password. Contact the service provider for information required to make the connection.
- 3. Confirm with OK to exit BenQUtility. When the WLAN connection is made successfully, the WLAN indicator on the right lights up in blue. And you are ready to activate programs that require network connectivity.
- Using the microSD card
FCC regulations
• This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
• This device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiated
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.