User's Manual

Appendix: Using Multi-Display Administrator 39
Setting up display configurations
You can use the settings and options on the Control panel to remotely set up various
settings for a selected display or display group on the Monitor list panel.
Information tab
The following information will be provided on the Information tab when a display is
selected on the Monitor list panel.
Some controls and settings on the Control panel may not be available depending on your display
model. A warning message will appear in the Notification area on the lower left corner of the
program window if an unsupported control or setting is selected.
Item Description
Display
Model name Model name of the display.
Serial number Serial number of the display.
Monitor SW version Software (firmware) version of the display.
IP
Configuration
Remote
Control
DHCP/Static
IP assignment method of current Ethernet
connection.
MAC Address
Network properties of current Ethernet
connection.
IP Address
Subnet Mask
Default Gateway
Status
Power Current power on/off status of the display.
Video Source Video input source being used by the display.
Signal Status Current input signal strength of the display.
Volume Mute Audio mute on/off status of the display.
Picture Mode Current picture mode setting of the display.
Aspect Current aspect ratio setting of the display.