Operation Manual

English
47
Press
▲▼
arrow and Enter key to select network and its settings:
IP Address: To specify an IP address, press the Enter button to show the IP address input
window. Use the
◄►
button to select the number in the address to be changed. Use the
▲▼
button to increase or decrease the number in the IP address.
Subnet Mask: Set up IP address of subnet.
Gateway: Set up IP address of gateway.
DHCP: Set DHCP to On or Off. If this is set to On, the DHCP server of the network domain
assigns an IP address to the projector. That is, the IP address is displayed in the address window
instead of being entering manually. Otherwise, the domain does not or cannot assign an IP
address, and 0. 0. 0. 0 is shown on the IP address window.
Apply: Select this button and press Enter. It takes several seconds to execute the change in
network settings till the following message disappears.
For further information on network control connections and settings, please refer to the
Remote control manual.
• RS232
Baud Rate: Set transmission speed to: 115200, 57600, 38400, 19200, 14400, 9600, 4800, and
2400. Transmission speed shall vary with length of RS-232 cable (longer cable requires slower
speed). In case of unstable signal or connection failure when controlling with RS-232 cable, try
downgrading the transmission speed.
Channel: You can send RS-232 control commands to your projector through the RS-232 port
or external digital transmission box connected to its HDBaseT/LAN port. Please set up the
following communication channel before sending control commands:
Local: Send RS-232 control command through your projector’s RS-232 port. Please set up
proper transmission speed in advance.
HDBaseT: Send RS-232 control commands to your projector’s HDBaseT/LAN port through
an external digital transmission box. The transmission speed is automatically set to 9600.