Operation Manual
English
46
OSD menu - CONTROL
• Standby Mode
Press
◄►
arrow key to toggle switch between Standard, ECO and Network mode.
Standard: The projector can be turned on using the remote control, RS-232 command or
network control.
Eco: The projector maintains in the standby status at the lowest power (<0.5W). In this mode,
the projector can be turned on only using the power button on the remote controller or
projector.
Network: The projector maintains in the standby status at the power comsumption under 6W,
the projector can be turned on using the power button or network control only, RS-232 control
command and wired remote control signal via external transmitter through RJ45 cable are not
available.
Note:
Some of communication port are turned off if it's set to ECO or Network mode, please make sure that the standby
mode is set to proper setting.
• Auto Power off
The default setting is Off. The projector powers off automatically after 20 minutes without input
signal when set to On.
• Direct Power on
The default setting is Off. The projector powers on automatically once it is connected to any AC
power supply if set to On.
• Network
Youcanusethenetworkfunctiontocongureanetworkforprojectorcontrol.